Minimig Discussion Forum

Does Minimig have, or is anyone working on adding a Wishbone bus (opencores.org) to Minimig?

I have a different FPGA board that I'd like to port Minimig to, and it has a number of connectors on it that could make use of some of their open-source cores, would be interesting to play with. Maybe I'll have to play with adding Wishbone myself?

Wishbone is not present yet in Minimig, because it was/is not necessary due to a too small FPGA present on the V1.x based boards.

Sure it would be possible to add a Wishbone Bus to each of the available cores working parallel inside a much bigger FPGA.

I have a XC3S1500 board which should have room to play with a few things. Will take a while to port though, I need to figure out storage as there is no SD slot. I do have an addon PCMCIA slot for a CompactFlash adaptor, but will need to add a path to there as well as whatever else needs done to get things working here.